• 0 Posts
  • 8 Comments
Joined 10 months ago
cake
Cake day: March 8th, 2025

help-circle

  • The idea with the first valve is to drive it with an H-bridge. This allows for reversing polarity and is commonly used with motors to allow for spinning in two directions. This requires 4 MOSFETs. I’m not sure what type of MOSFET you are using but if you can find a simple dc motor to test this setup you can verify that it works with the one you have before you extend the circuit to an H-brigde configuration. This would be cheaper than buying another valve. You’d need two GPIO pins and careful design to not short circuiting the H-bridge.



  • Could you clarify a few things? The circle symbol is meant to represent the voltage supply? Is it connected correctly? When you say solenoid, you mean an electromagnet, right? If so, why does it require that specific pulse with? You say you swapped out the LED for the coil, was the LED tested with MOSFET and diode in place? Does the solenoid engage when you take the connection off the RP2040 and drive it high directly? How did you ascertain the functioning of the solenoid by means of measuring resistance?



  • Of all the things wrong with this, what sticks out to me how he seemed to be offended when you put down your boundaries. I feel sorry for your sister and i would share this with her. If he behaves like this with his own family, it doesn’t bode well outside of it. Yeah, perhaps replying wasn’t the best idea but i cannot put myself in your position vis-a-vis your state of mind at the time but it doesn’t take away the lack of appropriateness of his comments.