I in the process of doing that, but the most problematic thing is the keyboard shortcuts IMO. All the apps have their own default shortcuts, all defaulting to ctrl + * instead of cmd + *

Cool, i never really understood/knew the reasons for the Nextcloud fork. When you say ‘we’, does it mean you are affiliated with opencloud? What would my reasons be to use opencloud over owncloud?

I have ordered a used x280 (only 8 gb ram), it was not at all that cheap though… i could probably have scored one way cheaper if i had a little more patience.

Very cool! This is what i was hoping to find - TY. Do you have it in your contract?

I would like to do it outside company time, but on their machine if possible, but if not, i’ll just get another machine. But as others have stated there are some small print that says something like - knowledge gained through company activities will be their IP, it’s somewhat vague and can be interpreted in different ways

Yea i thought about that, but part of the motivation is building my resume

I would like to use the company machine if possible, but outside of work hours. My current contract is formulated in vague terms with references to the applicable laws (Denmark), so i’m sure it’s legal.

I guess it’s because i vibrate the mold and not the mix directly as others have suggested

The next one did only get slightly better :( I vibrated it something like two minutes with the saw. Could it be bubbles forming from the mix? Maybe something about the plasticizer? Anyway i kinda don’t want to keep redoing this, i’m thinking about filling the holes and using it anyway, though it might crack due to freezing temperatures at some point i guess…

// Edit: specified that it was maybe slightly better

Thank you for the elaborate response. The second batch is now vibrated a whole lot more than the first one and i weighed the mixed beforehand. It’s just a premixed bag for setting posts i’ve used. 0-8mm. It’s really a pleasure to see the concrete vibrate into place. I am curious whether i’ve now also vibrated the pour down between the two parts of the mold too… We’ll see in a few days i guess.

Ty, used spray oil, seemed to work ok

I forgot i had this, will try it though the frequency is probably lower than what you suggest.

deleted by creator

Thank you for the advice. Do you really think a toothbrush will work? ^^ I read somewhere that oil spray (you know for pans and stuff) was good, so i tried that and it seemed to work fine, the form slipped pretty easily.

I want to make a drain where this puddle forms, but stock drains from hardwarestores expects more difference in the ground levels. I only have a few centimeters to work with to a french drain around the corner, so i want the outlet to be on the side close to the surface. I have a drain grate that will fit on top of this thing.

Well i just tried holding the bottom of my multicutter onto the mold, probably was not enough. Maybe if i put the entire thing on a plate i can vibrate the whole plate somehow…

Nice

Cool. I was of the understanding that a big part of the corneal damages leading to vision loss was due to vascularization. I was missing some perspective on that in the article.