Thank you! Makerlab is great. I have an X1 Carbon and can fully take advantage of this.

How can I use the Hunyuan 3D 3.0 model? I’ve got decent hardware, can I run it on my own machine? If not, how would I go about using it?

Does this help at all?

Try explicitly setting your DNS servers to either cloudflare (1.1.1.1 and 1.0.0.1) or google (8.8.8.8 and 8.8.4.4) and see if that has any effect.

If that does not help, make sure you’re getting a good signal from your router. Move your PC and router closer together for testing purposes to rule out wifi interference.

Troubleshooting issues like that are often a matter of ruling things out as best you can to track down the cause.

If it ain’t broke…

Go around and smell everything that you touch; doorknobs, your phone, mouse, keyboard, tools, refrigerator door handle, pets, etc. something you routinely touch is foul. Some thermoplastics smell really awful when they start to degrade. I hope you find it.

This is going to be an unpopular opinion because most people like to think of themselves as nice. I think it’s not so much that there are nice people and assholes, but rather that almost everyone is an asshole some of the time.

😐

They’re not all gone. I own an online community that I have been running since 2001. The only changes I’ve made was a redesign to make the site responsive to all screens. They’re out there.

Stop Eating

I keep mine next to my balls

Your dad is an isopod!

Apparently they get 15% off at Comfort Inn

I remember when 128MB RAM sticks were $400

Get off my lawn

Don’t feel bad, you come from a long line of men who got it done before buyer’s remorse set in.

After the Ender 3 Pro, I got a Bambu X1 Carbon. I have been running it for over a year now and it just makes whatever I send to it. The few times it has needed my attention, the instructions were clear and easy to follow.

How much VRAM does your machine have? Are you using open webui?

Are you good with the games that involve killing other people against their consent?